The unique construction of the aerator (the rotor + stator). Low peripheral speed of the rotor in the range 5.5 - 6.5 m / s, depending on the specific gravity and grain composition of ore. Thanks to guaranteed employment for the aerator is 60 months - for the main flotation or control, and 90 months for the flotation cleaning.
The unit power consumption in the flotation process is in the range 0.7 - 0.8 kW/m3.
EFFECTIVE COLLECTION FOAM
Receive foam product (concentrate) with gutters placed radially. Depending on the size and type of flotation flotation shall be 4 - 8 gutters. This allows you to accurately and reliably determine the amount of foam product received.
Protecting the bottom and side walls of the chamber, the impact of the aerator, using a rubber liner.
Single chamber EFFICIENT FLOTATION
The possibility of single flotation machines for the flotation of coal, graphite, sulfur, or for cleaning flotation of ores, flotation machine IF-xxRC. In flotation machine the pulp (transmission) flows counter currently in relation to the movement of air bubbles (as in flotation columns.)
For the regulation and stabilization of pulp are used in valves, a "cap" on the linear flow characteristics, or butterfly - for the flotation of coal, sulfur, graphite.
Checking and adjusting the level of pulp in a single flotation chamber or in the flotation machines (in one section can be installed in a common level of 2 - 3 flotation machines.
Control of pulp levels in the chamber by means of the ultrasonic sensor float.
AIR FLOW UNDER CONTROL
Individual control and regulation of air flow to the aerator.
Automatic process control
The automatic control of flotation machine performs the functions of regulation, registration trends in measured parameters, signaling devices work, change the set point controller and visualization of the machine.
The automatic control system uses PLC FANUK reputable manufacturers, Schneider, Siemens, SAIA, ALLAN BRADLEY (depending on the wishes of the investor)